Bronsun Lash & Brow Trial Kit - Brown

• 1 x Bronsun Gel Dye (7ml)
• 1 x Milk Cream Developer 3% (5ml)
• 1 x Plastic Mixing Cup
• 1 x 2mm Micro Brush
• 1 x Instruction Sheet

FEATURES

• Long Lasting Effect Tints Both Hair & Skin
• Easy to apply Gel Texture - No leaking
• Ammonia Free Formula

DIRECTIONS

FOR BROWS:

• Perform a patch test 24-48 hours before application
• Cleanse the eyebrow area with an oil-free makeup remover. If needed, degrease the skin and hairs using Saline Solution or Lash Primer.
• Apply Zone Gel or White Eyebrow Paste around the eyebrows, avoiding areas to be tinted.
• Thoroughly mix Milk-cream Developer BRONSUN and Eyelash and eyebrow dye BRONSUN in a 1:1 ratio until well mixed. (We recommend around .5cm of the dye and equal part of the developer)
• Using a brush, quickly and evenly apply a thin layer of the prepared mixture to the eyebrows, shaping them as desired. Be careful not to touch the skin.
• Leave the dye on eyebrows for 10-20 minutes, depending on desired intensity.
• After the recommended time, remove the dye using a wet cotton pad. Wash off any residue with water. Keep eyes closed until all dye is removed.
• If you accidentally tint the skin, gently wipe the area with BRONSUN Remover using a microbrush or cotton swab. Repeat if necessary. Wash off residue with water.

FOR LASHES:

• Perform a patch test 24-48 hours before application
• Cleanse the eyelashes with an oil-free makeup remover. If needed, degrease the skin using Saline Solution or Lash Primer.
• Apply Zone Gel or White Eyebrow Paste around the eyes, avoiding the eyelashes. Place protective pads along the lower eyelid edge, ensuring the lower lashes are outside the pads.
• Thoroughly mix Milk-cream Developer BRONSUN and Eyelash and eyebrow dye BRONSUN in a 1:1 ratio until well mixed (We recommend around .5cm of the dye and equal part of the developer)
• Using a brush, quickly and evenly apply a thin layer of the prepared mixture to the eyelashes. Ensure eyes are closed during application.
• Leave the dye on eyelashes for 10-15 minutes, depending on desired intensity.
• After the recommended time, remove the dye using a wet cotton pad. Wash off any residue with water. Keep eyes closed until all dye is removed.
• If you accidentally tint the skin, gently wipe the area with BRONSUN Remover using a microbrush or cotton swab. Repeat if necessary. Wash off residue with water.

AFTERCARE:

• Avoid contact with water for 24 hours after the procedure
• Avoid aggressive cosmetic treatment (scrubs, peels, alcohol-containing products) and steam (baths and saunas).
• Do not use lotions, toners and creams in the eyebrow area.

STORAGE

Store out of direct sunlight between 5°C - 25°C

INGREDIENTS

Water, Cellulose Gum, Sodium Hydroxide, Sodium Sulfate, P-Phenylenediamine, Resorcinol, CI 16035, CI 73015.